The Question:

Date: Sun Nov 25, 2001 1:58 pm
Subject: exhaust manifold studs

Is there a tried and true method for removing the 4 exhaust manifold studs from the heads on a small block?

Are they even meant to be removed? I want to use the old ones from my 318 on my 340. I tried heat and a vise grips last night, but couldn't get them to turn.

Thanks folks.

The Answer:

Date: Sun Nov 25, 2001 2:44 pm
Subject: Re: [BarracudaOwners] exhaust manifold studs

Take two nuts and install them on the threads of the stud. Then back the inside nut up against the outside nut. This will act as a locking mechanism and you get an open end on the inside nut to turn the stud. Use plenty of WD too.

Tim Moller